![dual boot mac pro 2008 dual boot mac pro 2008](https://cdn.osxdaily.com/wp-content/uploads/2010/02/macbook-pro-with-dual-cinema-displays.jpeg)
- #DUAL BOOT MAC PRO 2008 INSTALL#
- #DUAL BOOT MAC PRO 2008 DRIVERS#
- #DUAL BOOT MAC PRO 2008 WINDOWS 10#
The first step is to shrink the Windows partition to make some space for Linux:
![dual boot mac pro 2008 dual boot mac pro 2008](https://9to5mac.com/wp-content/uploads/sites/6/2017/01/windows-10-macbook-pro-boot-camp.jpg)
#DUAL BOOT MAC PRO 2008 INSTALL#
Create Partition for Linuxįor the purposes of this article, I'm going to install Kali Linux, that's what I used, but installation with ANY version of Linux should work the same way.
#DUAL BOOT MAC PRO 2008 WINDOWS 10#
Now that you have an Apple-supported dual-boot system running macOS and Windows 10 (presumably), it's time to perform the Linux installation. See this table to check your hardware and what versions of Windows are supported on it. There is no way to install an earlier version of Windows using Boot Camp on newer hardware. Note: Apple only supports Windows 8.1, or newer, for hardware released after 2014. Adjust if you wish, I used a 196GB partition for Windows 10, then split it into 128GB for Windows and 64GB for Linux (FYI, a Windows 10 installation with Office 365 installed takes up 68GB, so give yourself enough room under Windows). You will have supported ways to control the Windows and macOS boot process on your MacBook from within Windows (via the Boot Camp Control Panel)Īpple's official documentation for Boot Camp is found here.įollow Apple's instructions for installing Windows, but make sure you create the Windows partition approximately 64GB larger than what you want to end up with for Windows, that space will end up being given to Linux.